Wiring Tips for Your Bonsai
Wiring Tips for Your Bonsai Tree: The art of bonsai is related to the construction and training of a tree. No matter what style and type you choose for your bonsai, it will be your job to train its branches gently but firmly so that they grow the way they want, and keep the tree from growing.
Wiring Tips for Your Bonsai Tree is in the middle of the process of molding, and it is similar to using toothpaste. The function of the fence is to hold the branches in place by putting sufficient pressure to keep them from leaving the position. Steel or aluminum wire may be used; these two types of wire are easy to bend, less visible than other metal wires, and less likely to cut tree bark and leave scars.
There are various ways to add a bonsai to a phone depending on the type of tree and the specific shape or style of bonsai you are following. The following are some basic tips for using the phone to shape your bonsai:
Wiring branches
To start at the anchor and use the pliers to bend the rope gently, tie a branch to the wire to move it to the desired location. Fold the wire to the opposite side of the clock and not sharply above 45 degrees.
Always start with hard branches and work on smaller ones near the top of the tree. Keep natural bends and branch shells in mind when connecting wires, and never force a branch to go in a completely different direction than it would naturally grow.
Wiring branches
You will need to wrap small branches or shoots nearby, and never put a fence in a green or sprouting branch. Fold the branches and shoots from below and up the tree. If the branch breaks during the Wiring Tips for Your Bonsai Tree, you can put the broken part back in shape and wrap it in garden tape, or you can cut the broken branch back to where it broke.
Anchor
Many bonsai hobbies begin the process of molding by wire to attach a branch anchor or branches to a container or ground. This is especially true of large branches. This procedure can also be applied to a tree trunk. First, pull the string over the branch you want to tighten and secure the other end to the pot or other branch or stem. Discomfort on the phone should be dirty, but not bad enough to damage the bonsai bark.
When to Call
Many deciduous trees, or those that lose their leaves, should be pruned when their leaves are ripe, early in the summer. If your drug is growing rapidly, some experts recommend removing the cord during the growing periods (during treatment). This will avoid overcrowding, which can cut through the bark and leave scars.
Coniferous trees with needles, such as pine, should be attached to the winter before the growing season. Outdoor bonsai should be protected from cold, heat, and heavy winds, and rain for at least a month after the rope.
Once the bonnet is wired, pay close attention because as the tree grows, its branches will grow slowly, and you do not want the wire to get into the bark. Remove any hardened wire by cutting. The general rule is to leave the ropes open throughout the growing season, in spring and summer in most cases, and then remove them in the fall. You can also rewire if your bonsai has not reached the desired level.
https://writing-coach-4-u.blogspot.com
0 Comments
Post a Comment